The iC SmartView Config service is a part of the iC Workbench and iC Niagara Expansion Pack (from version 4.14). It can also be downloaded as a standalone module from the iC Connect platform. If it is downloaded as the standalone module, it must be placed it in an appropriate space of the Niagara instance in the modules folder.
To start using the iC SmartView Config service, go to the Palette window and select the Open Palette option.
Confirm with OK, the palette is ready to use in the Palette window.
The only location where the service will operate properly is Config → Services.
Drag and drop elements from the iC SmartView Config according to the following structure:
-
Config
-
Services
-
iCSmartViewService (only one component allowed!)
-
iCSmartViewRecipient (one component per panel to be configured, more than one allowed)
-
extensions.
-
-
-
-
Note
Use of folder components is voluntary. The RecipientsFolder component can be used to group the iCSmartViewRecipient components (for example, panels from common location).
Alternatively, drag and drop a fully loaded predesigned example for a relevant panel type.
Warning!
For a full functionality of the service, it is required to approve the Niagara public certificate.
In a first step, after dropping the iCSmartViewRecipient component under the iCSmartViewService, its status will be fault, showing the SSLException: Recipient device certificate was not approved! fault cause.
To fix this, go to the AX Certificate Management → Allowed Hosts and approve the certificate.
Go back to the iCSmartViewRecipient component, refresh it (or disable/enable). The component is now fully functional.