Skip to main content
Skip table of contents

USB Configurator Installation

Hardware Requirements

  • Processor: last generation;

  • RAM: 2 GB;

  • operating system: Windows 7, Windows 10;

  • .NET Framework 4.6.1 (or higher);

  • USB to micro USB cable;

  • not fully compatible with 800x600 screen resolution.

Note: The .NET Framework may not appear in the list of installed software on Window 10, as it is already installed by default by the operating system.

Software Setup

This tool is supplied with a self-installing file: MVE-2-RS USB Configurator or MVE-2-RS RS485 Configurator.

By starting the self-installing file, depending on the operating system, the user may be asked to give permissions to make changes to the device; to confirm, click the Yes button.

During installation, a message will appear informing the user that the destination folder does not exist, and if it is to be created, click the YES button.

Once the configurator has been installed, go to the folder of the new program (Program Files (x86)\MVE-2-RS USB Configurator), and click twice on the installer file, sam-ba_2.18.exe, that will start the installation wizard of the software necessary to use the firmware upgrade functionality via USB.

WARNING!

Without the sam-ba_2.18.exe file installed, the firmware upgrade function is not available.

Follow the instructions shown in the guide screens without changing anything.

At the end of the installation, the Atmel folder will be created in the Program Files (x86) folder, which contains the sam-ba_2.18 folder; these two folders must not be deleted or modified.

After the installation wizard is finished, the software is ready for use.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.