Skip to main content
Skip table of contents

AAC20 - Application - Error during application upload in the iC Tool

Issue

Sometimes, during application upload in the iC Tool, the Console displays an error log: Could not upload application to the device.

image-20240129-143244.png

Figure 1. Error while load the application cause by a missing kit

Solution

In this case, the reason for the error log in the Console is a missing ConstFI component from the control kit. To solve this issue, before uploading the application, upload required kits to the device. A list of the required kits is available by opening the app.sax file in any text editor.

image-20240129-144037.png

Figure 2. A list of kits required before uploading the application

After uploading required kits, upload the app.sax file using the Application Manager.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close