Skip to main content
Skip table of contents

Default Settings

Out of the box device as well as after restoring default values procedure, has got the following default settings:

Name

Default Value

User baud rate

76800

Stop bits

1

Data bits

8

Parity bits

0

Response delay

0

I1-I4 digital input counters

0

Non-volatile values stored in the EEPROM memory

Cleared

I/O configuration

Cleared

Default values

Restoring Default Settings

To restore the default iSMA-B-FCU device settings, follow the steps below:

Step 1: Turn the power supply off.

Step 2: Set the 6th switch of the Protocol DIP switch to ON.

Step 3: Turn on the power supply, wait until the power LED blinks.

Step 4: Set the 6th switch of the Protocol DIP switch to OFF to restore the default settings. To cancel the reset, turn off the power supply, and set the 6th switch of the Protocol DIP switch to the OFF position.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.