Skip to main content
Skip table of contents

AODigital

The AODigital component allows to control the analog output in dry contact mode.

AODigital component

Slots

The AODigital component has the following slots:

  • Status: shows the component’s status;

    • Available information: OK (the component is working properly), Fault (the component is disabled);

  • Fault Cause: shows the reason of the Fault status;

  • Address: allows setting an address of a physical output of the device; once the component has been added to the folder, the slot's default value is 1—for the component to operate properly, the unique address value must be set in this slot;

    • Available settings: AO1-6.

  • Out: a value transferred from the In slot and then to the physical output;

  • In: a value read from an application or network and then transferred to the Out slot.

Action

The AODigital component has one action available:

  • Set: allows to manually set the In slot value.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.