Skip to main content
Skip table of contents

Inputs and Outputs

The device is equipped with inputs for two different purposes.

The two digital inputs, I1 and I2, are designed for physical ON/OFF switches connection, both monostable or bistable type, in order to control the DALI ballasts connected to DALI1/DALI2 terminals. Depending on a particular CFG DIP switch configuration, I1/I2 can control single DALI network or both DALI1 and DALI2 networks simultaneously. For details, please refer to the table in CFG DIP Switch section.

The other two digital inputs are designed for blind control (up and down movement). In case of the blind/shutter control, up and down switches can be connected.

The two special inputs, SI1 and SI2, are designed for connecting motion sensors / presence detectors in order to use them in the light control algorithm.

The device is equipped with three types of outputs: 2 light outputs, 1 blind output, 1 power supply output (24 V DC).

Each of the outputs has a different purpose and a maximum available load.

The light and blind outputs are fuse-protected.

WARNING! The maximum current for the light outputs, blind output, and 24 V DC power supply output is 8 A!

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.