Skip to main content
Skip table of contents

MVE-2-RS Configurator User Manual

Introduction


The MVE-2-RS Configurator allows to configure and monitor the MVE-2-RS actuator for a proper system commissioning, monitoring, and troubleshooting.

The connection between a computer and actuator can be established either by using a USB/RS485 converter (iSMA-B-CVT-RS485) with a serial communication bus and the Modbus protocol (RTU) or by the micro USB port.

Two different configuration tools are available:

  • the MVE-2-RS RS485 Configurator suitable for the configuration and real-time monitoring of the actuator by the Modbus RTU protocol; the USB/RS485 converter (iSMA-B-CVT-RS485) is required;

  • the MVE-2-RS USB Configurator suitable for the configuration and diagnostic of the actuator (not suitable for real-time monitoring) by USB; a simple micro USB-USB cable is required.

Revision History

Rev.

Date

Description

1.0

19 Jul 2022

First edition

1.19 Nov 2022Updated table of Modbus register database
1.225 May 2023

Updated the default stop bit (it was 2 it become 1)

1.36 Oct 2023Add Phase 2 (BACnet and energy, power loop and limit function)
MVE-2-RS Configurator revision history
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.