Skip to main content
Skip table of contents

SfAR Modules - Outputs - Problem with bad precision in Niagara and lack of current on analog outputs

Issue

After connecting the SfAR module with the Niagara controller and adding the AO point, the output is not precise and there is no current.

Possible solutions

  1. Restore factory setting on the device.

  2. Update the firmware to the latest version. If the latest firmware has already been uploaded, reload it.

  3. Check if the Conversion parameters in the AO point are set to Linear with 0.1 scale and 0.0 offset.

image-20240507-060058.png

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close