Sensors Parameters
Warning!
This section applies to all Touch Point series: the Control Point and Control Point VAV series.
The Control Point panel supports 3 types of sensors, all of which are equipped with configurable software filter and user offset. Values measured by sensors can be shown on the device’s display or read through communication protocols.
Information about available sensors can be read from the following register or in the iSMA Configurator:
SENSORS: contains an information about the sensors built-in the panel according to the table below (if the bit is active, it means the sensor is built-in in the panel):
Bit | Built-in Sensors |
|---|---|
0 | Humidity sensor |
1 | CO2 sensor |
2 | Temperature sensor |
Sensors built-in in the panel
Modbus register: 30029;
BACnet object: MSI1, property: Present Value.