Skip to main content
Skip table of contents

AAC20 Updater User Manual

Introduction

AAC20 Updater is a software designed to administer an operating system of the iSMA-B-AAC20 controller. The software is free and can be obtained from iSMA distribution partner or downloaded from the iSMA CONTROLLI website: iSMA CONTROLLI Download Center. The software allows to perform the following actions:

  • Send File: sends a file to the device, displays the transfer progress bar at the bottom of the window, correct transfer is confirmed with a message "Transfer complete";

  • Reload Firmware: uploads a firmware file–this operation must be preceded by a transfer of an adequate firmware files to the device. Upon update, the device shall be rebooted;

  • Device Reboot: reboots the device;

  • Default Settings: sets default values of IP address, RS485 parameters, and platform password;

  • Console: displays the operating system console.

AAC20 Updater communicates with the device in two ways:

  • Modbus TCP: using the Ethernet port;

  • Modbus RTU: using the RS485 port–this type of communication requires the device to be in the bootloader mode.

The software allows to connect using the IP connection, RS485 port, or USB A-to-A cable connection (USB only for power supply or/and diagnostic to read console).

Revision History

Rev.

Date

Description

1.0

19 Jun 2024

First edition

Revision history


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.